Quantcast

Documentation Center

  • Trial Software
  • Product Updates

Functions in Vehicle Network Toolbox

  • By Category | Alphabetical List
  • CAN Communication

    Hardware Connection

    canHWInfo Information on available CAN devices
    canChannel Construct CAN channel connected to selected device
    discard Discard all messages from CAN channel
    CAN.VendorInfo Display available device vendor information
    CAN.ChannelInfo Display device channel information
    configBusSpeed Set bit timing rate of CAN channel
    get Return property values
    set Configure property values
    canTool Open Vehicle CAN Bus Monitor

    Install Hardware Support

    supportPackageInstaller Find and install support for third-party hardware or software

    Monitor Vehicle CAN Bus

    canTool Open Vehicle CAN Bus Monitor

    Transmit Messages

    canMessage Build CAN message based on user-specified structure
    pack Pack signal data into CAN message
    start Set CAN channel online
    transmit Send CAN messages to CAN bus
    replay Retransmit messages from CAN bus
    canMessageImport Import CAN message log file from third-party tool
    transmitConfiguration Display messages configured for automatic transmission
    transmitEvent Configure messages for event-based transmission
    transmitPeriodic Configure messages for periodic transmission

    Receive Messages

    receive Receive messages from CAN bus
    attachDatabase Attach CAN database to messages and remove CAN database from messages
    stop Set CAN channel offline
    unpack Unpack signal data from message
    extractAll Select all instances of message from message array
    extractRecent Select most recent message from array of messages
    extractTime Select messages occurring within specified time range from array of messages

    Message Database

    canDatabase Create handle to CAN database file
    messageInfo Information about CAN messages
    signalInfo Information about signals in CAN message

    Filter Messages

    filterAllowAll Allow all messages of specified identifier type
    filterAllowOnly Configure message filter to allow only specified messages
    filterBlockAll Configure filter to block messages with specified identifier type

    XCP Communication

    Message Database

    xcpA2L Access A2L file
    getEventInfo Get event information about specific event from A2L file
    getMeasurementInfo Get information about specific measurement from A2L file

    Hardware Connection

    xcpChannel Create XCP channel
    connect Connect XCP channel to slave module
    disconnect Disconnect from slave module
    isConnected Return connection status

    Acquire and Stimulate Measurements

    createMeasurementList Create measurement list for XCP channel
    viewMeasurementLists View configured measurement lists on XCP channel
    freeMeasurementLists Remove all measurement lists from XCP channel
    startMeasurement Start configured DAQ and STIM lists
    isMeasurementRunning Indicate if measurement is active
    readDAQListData Read single value of specified measurement
    writeSTIMListData Write to specified measurement
    stopMeasurement Stop configured DAQ and STIM lists

    Read and Write Data to Memory

    readSingleValue Read single sample of specified measurement from memory
    writeSingleValue Write single sample to specified measurement
    Was this topic helpful?